- This topic has 0 replies, 1 voice, and was last updated 10/18/20236:47 am by GoldcorpArmory.
Viewing 1 post (of 1 total)
-
Posts
-
GoldcorpArmory
I am new to 3D printing and was hoping some folks with experience can share some recommendations for a good starter printer? This would likely be for printing some firearm parts, etc. so it would obviously need to be high quality enough to make really sound prints from good material.
What’s a good place to start that isn’t going to break the bank?
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.